Starting the Quick Encoders

The easiest way to get encoding up and running right away is using the "OneClick" encoder templates.

Step 1    Select OneClickAudioEncoder-1

Step 2    Click on start. If your MediaBox is equipped with a   RealServer, you don't need to change any settings. The encoder will connect to the RealServer and it will start streaming.

(Make sure you have an audio feed connected to "LINE IN". The OneClickAudioEncoder-1 audio capture card is the on board card. Line in and Microphone jacks are located in the front of the Box)

 

 

Step 3  Click on the "Back to the main page”

 

 

 

Step 4  On the main page you will notice that a "Listen link" is now active.

Click on the  link to launch your RealPlayer.