Starting the Advanced Encoders

The Advanced encoder templates provide you with full control over the RealMedia encoders.

Please note that the encoders templates are pre-populated with default values so that you can start encoding right away. Start by changing one value at the time in order to notice changes in the behavior of the encoder.

 

 

 

 

 

 

 


 

Step 1   Select G2AudioEncoder-1

Step 2   Click on start. If your MediaBox is equipped with a     RealServer, you don't need to change any settings. The encoder will connect to the RealServer and it will start streaming.

(Make sure you have a audio feed connected to "LINE IN". The OneClickAudioEncoder-1 audio capture card is the on board card. Line in and Microphone jacks are located in the front of the Box)

Step 3   Click on the "Back to the main page”

Step 4   On the main page you will notice that a "Listen link" is now active. Click on the   link to launch your RealPlayer.